Filter
Top Products
22
Before using
Adjust the length of the grip belt so that it fits your
hand, and hold it properly.
1 Open the belt cover and loosen
the belt.
2 Work your hand through the grip
belt and fasten the belt.
≥Slip your hand through the belt as far as it
goes so that your fingers will grip the
rubber area firmly.
≥Tighten up the belt so that your hand
remains firmly in place.
≥When loosening the belt, please take care so
that the belt does not come away from the grip
belt stopper A.
This is for installing the shoulder belt and
carrying the camera on your neck or shoulder.
1 Thread the belt through the
shoulder belt installation hole A.
≥Thread the belt through the fastener after
threading through the shoulder belt
installation hole. At least 2 cm of the belt
must extend from the fastener.
2 Install the belt on the other
shoulder belt installation hole.
Using grip belt
Correct
Incorrect
Shoulder belt installation hole
VQT1Q93_ENG_PP.book 22 ページ ２００８年３月６日 木曜日 午後５時４２分