Filter
Top Products
VQT1S36
50
Advanced (Recording pictures)
• Refer to P58 for details about the Aperture-priority AE, Shutter-priority AE, and Manual
exposure.
• In Intelligent auto mode, shutter speed changes depending on the identified scene.
• In advance scene modes (P63) and [SCENE MODE] (P66), the shutter speeds will differ from
those described above.
¢2 The shutter speed becomes a maximum of 1 second in the following cases.
– When the optical image stabilizer is set to [OFF].
– When the camera has determined that there is little jitter when the optical image stabilizer is
set.
¢3 The maximum shutter speed is selected when the amount of jitter is minimal while
[STABILIZER] is set or when [STABILIZER] is set to [OFF].
• It will become 1 to 1/2000th of a second in other advanced scene modes and scene modes.
Note
•
Do not bring the flash too close to objects or close the flash while it is activated. The
objects may be discolored by its heat or lighting.
• Do not close the flash soon after the flash is activated prior to taking pictures due to AUTO/
Red-eye reduction etc. It causes a malfunction.
• When you take a picture beyond the available flash range, the exposure may not be adjusted
properly and the picture may become bright or dark.
• When the flash is being charged, the flash icon blinks red, and you cannot take a picture even
when you press the shutter button fully. When [AUTO LCD OFF] is set, the LCD monitor
turns off and the power lamp lights.
• The white balance may not be properly adjusted if the flash level is insufficient for the subject.
• When the shutter speed is fast, the flash effect may not be sufficient.
• When taking a picture with the flash, we recommend removing the lens hood. In some
cases it may not allow the scene to be illuminated properly.
• It may take time to charge the flash if you repeat taking a picture. Take a picture after the
access indication disappears.
• The red-eye reduction effect differs between people. Also, if the subject was far away from the
camera or was not looking at the first flash, the effect may not be evident.
• Flash is fixed to [Œ] when the [CONVERSION] (P93) is set to [ ] or [ ].
Mode Shutter speed (Sec.)
• in mode 1/8 to 1/2000th
• in mode
• , and in mode
• :, ; and í in [SCENE MODE]
1 or 1/4 to 1/2000th
¢2
• in mode
• in mode
• in mode
• and in mode
• in mode
• in [SCENE MODE] (in shutter speed priority)
8 to 1/2000th
• 5 in [SCENE MODE] 15, 30, 60
• 4 in [SCENE MODE] 1/4, 2
¢3
C
DMC-FZ28P_PC.book 50 ページ ２００８年７月２日 水曜日 午後１１時１４分