Panasonic DMC-LX2 Digital Camera User Manual


 
Advanced
46
VQT0Y44
n Adjusting flash output
Adjust the flash output when the subject is
small or reflection ratio is extremely high or
low.
1
Press e [C] several times until
[ FLASH] appears and then
press w/q to set the flash output.
• You can adjust from [-2 EV] to [+2 EV]
in steps of [1/3 EV].
• Select [0 EV] to return to the original
flash output.
2
Press [MENU/SET] to finish.
You can also press the shutter
button halfway to finish.
• When the flash output is adjusted, the
flash output value appears on the upper
left of the screen.
• The flash output setting is memorized
even if the camera is turned off.
• In Auto mode [0], motion picture
mode [i], and [SCENERY] (P63),
[NIGHT SCENERY] (P64),
[FIREWORKS] (P66), [STARRY SKY]
(P67), [AERIAL PHOTO] (P68) or
[HIGH SENS.] (P68) in scene mode,
you cannot adjust the flash output.
• Do not look directly at the flash at
close range when it is activated.
• Do not bring the flash too close to
objects or close the flash while it is
activated. The objects may be
discolored by its heat or lighting.
• Do not cover the photo flash with your
fingers or any other items.
In economy mode, the LCD monitor
turns off and the status indicator blinks
while the flash is charged. [This does
not happen when using the AC adaptor
(DMW-AC5; optional).]
If the remaining battery power is low,
the length of time that the LCD monitor
turns off to charge may become longer.
The flash icon turns red when activating the
flash and pressing the shutter button halfway.
• When the jitter alert appears, we
recommend using a tripod.
• When you take a picture beyond the
available flash range, the exposure may
not be adjusted properly and the picture
may become bright or dark.
When taking a picture with the flash, the white
balance will be automatically adjusted [except
for [
x
] (Daylight), [ ] (Flash)], but the
white balance may not be properly adjusted if
the photo flash is insufficient. (P82)
• When the shutter speed is fast, the flash
effect may not be sufficient.
• When you repeat taking a picture,
recording may be disabled even if the
flash is activated. Take a picture after the
access indication disappears.
When the flash is being charged, the flash icon
blinks red, and you cannot take a picture even
when you press the shutter button fully.
Do not close the flash immediately after
using a secondary light source, for example
AUTO/Red-eye reduction [
s
]. Doing
so can damage the camera.
The red-eye reduction effect differs between
people. Also, if the subject was far away
from the camera or was not looking at the
first flash, the effect may not be evident.
• When you set burst mode or auto bracket,
only 1 picture is recorded for every flash
activated.
• You can extend the shutter speed by up to
1/8 by using exposure compensation.
Sand or seawater may cause the camera to
malfunction. Make sure that sand or seawater
does not come in touch with the flash.
MENU
FLASH
SELECT EXIT