Filter
Top Products
71
5
Chapter 5 Preparation (continued)
Reading out the Lens File Data
1 Select the lens file No. to read out by following Steps 1
to 3 in the [Storing the Lens File Data] section.
2 Turn the JOG Dial button to move the cursor to
[READ:].
3 Press the JOG Dial button and the following message
appears.
4 Turn the JOG Dial button to move the cursor to [YES].
Then, press the JOG Dial button.
[READ OK] will be displayed after the stored lens file
data has been read out.
5 Press the MENU button to exit the menu operation.
Resetting Lens File Data to Factory Standard
Settings
The lens file data can be reset to the standard setting values
that were set when the camera was shipped from the factory.
From the FILE page, open the <INITIALISE> screen.
1 From the INITIALIZE screen, select [RESET LENS
FILES].
2 When the JOG Dial button is pressed, the message
shown below appears.
3 Turn the JOG Dial button to move the cursor to [YES],
then press the JOG Dial button.
[OK] is displayed, resetting the lens file data to the
factory default values.
5($'"
<(6
12
,1,7,$/,6(!
5($')$&725<'$7$
:5,7(86(5'$7$
5(6(7/(16),/(6
5(6(7$///(16'$7$"
<(6
12
#,52%2'PINKUJDQQMࡍࠫ㧞㧜㧜㧡ᐕ㧝㧞㧤ᣣޓᧁᦐᣣޓඦᓟ㧝㧞ᤨ㧠㧥ಽ