Filter
Top Products
96
Chapter 7 Maintenance and Inspections (continued)
5. P2 Card Fully Recorded
Display window
indication
All 7 bar indicators for remaining MEDIA
capacity start blinking.
WARNING lamp
Continues to light up until an operation is
performed.
Tally lamp
Continues to blink 4 times per second until
an operation is performed.
Viewfinder The END indicator blinks.
Warning tone
Continues to beep until an operation is
performed.
Warning
description
The P2 cards are recorded to maximum
capacity.
Recording/
playback operation
The recording stops.
Countermeasures
Delete the clips in the P2 card or insert a
new P2 card.
7. Low Wireless Signal Reception
Display window
indication
No display.
WARNING lamp
Blinks 4 times per second. (During pause
and recording)
Tally lamp
Blinks 4 times per second while recording
continues.
Viewfinder
The WIRELESS RF indicator lights up while
recording continues.
Warning tone
Beeps 4 times per second while recording
continues.
Warning
description
This error indicates poor wireless audio
reception conditions.
Recording/
playback operation
Continues to operate without receiving the
wireless microphone signal.
Countermeasures
Check the microphone power supply and the
reception status of the wireless receiver.
6. Recording Error
Display window
indication
“00:00:00:11” appears in the time code
display field. Even after recording is stopped,
this display continues to blink until the next
operation is performed.
WARNING lamp
Blinks 4 times per second while recording
continues.
Tally lamp
Blinks 4 times per second while recording
continues.
Viewfinder
The REC WARNING indicator lights up.
Warning tone
Beeps 4 times per second while recording
continues.
Warning
description
This indicates a failure either in the P2 card
recording or the recording circuit.
Recording/
playback operation
Recording stops.
Countermeasures
Restart recording. Or, turn the power OFF
and turn it ON again, before starting
recording.
8. 1394 (when AJ-YAD800G is attached)
Display window
indication
The 1394 E-__ indicator in the display
window lights up.
WARNING lamp
Blinks 4 times per second while the
WARNING lamp recording is continuing.
WARNING lamp
Blinks 4 times per second while the TALLY
LAMP recording is continuing.
Viewfinder
In the case of Error Code 92, “1394 INITIAL
ERROR” indicator lights up (during pause
and recording)
For Error Codes other than Error Code 92, or
if REC SIGNAL is set to “1394”, no error is
displayed in the viewfinder.
Warning tone
Beeps 4 times per second while ALARM
recording is continuing.
Warning
description
This indicates a failure of the DVCPRO/DV
connector.
Recording/
playback operation
The operation continues, but input signals to
the DVCPRO/DV connector are abnormal.
Countermeasures
Check the connection between the
IEEE1394 cable and the DVCPRO/DV
connector, settings of any external device
and menus, and the turn on the power again.
If the warning indication is still illuminated,
confirm the “Error Codes” in the IEEE1394
interface board instruction manual, and
consult your distributor.
#,52%2'PINKUJDQQMࡍࠫ㧞㧜㧜㧡ᐕ㧝㧞㧤ᣣޓᧁᦐᣣޓඦᓟ㧝㧞ᤨ㧠㧥ಽ