Panasonic PV-GS320 Camcorder User Manual


 
Before using
15
LSQT1091
Power supply
ª
Charging the battery
When this product is purchased, the battery is not
charged. Charge the battery before using this
product.
Battery charging time. (
-16-)
We recommend using Panasonic batteries.
(
-12-, -79-)
If you use other batteries, we cannot guarantee
the quality of this product.
If the DC cable is connected to the AC adaptor,
then the battery will not get charged. Remove
the DC cable from the AC adaptor.
1
Connect the AC cable to the AC adaptor and
the AC jack.
2
Put the battery on the battery mount by
aligning the mark and then securely plug it
in.
ª
Charging lamp
Lights up:Charging
Goes off: Charging completed
Flashing: The battery is over discharged
(discharged excessively). In a while,
the lamp will light up and normal
charging will start.
When the battery temperature is
excessively high or low, the [CHARGE]
lamp flashes and the charging time will
be longer than normal.
ª
Connecting to the AC outlet
1
Connect the AC cable to the AC adaptor and
the AC jack.
2
Connect the DC cable to the AC adaptor.
3
Connect the DC cable to this product.
The output plug of the AC cable is not
completely connected to the AC adaptor jack.
As shown in 1, there is a gap.
Do not use the power cord for other
equipment since the power cord is exclusively
designed for this Camcorder. Do not use the
power cord from other equipment for this
Camcorder.
ª
Attaching the battery
Push the battery against the battery holder and
slide it until it clicks.
ª
Removing the battery
While sliding the [BATTERY] lever, slide the
battery to remove it.
CAUTION
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or
equivalent type recommended by the
manufacturer. Dispose of used batteries
according to the manufacturer’s instructions.
1
BATTERY
LSQT1091_ENG.book 15 ページ 2006年11月27日 月曜日 午後1時17分