Filter
Top Products
Before using
27
LSQT1091
ª Remote control usable range
≥The distance between the remote control and
the Camcorder: Within approx. 5 m (16 feet)
Angle: Approx. 10o up and 15o down, left and
right.
ª
Selecting the remote control mode
If 2 Camcorders are used simultaneously, set the
mode for one pair of Camcorder and remote
control to [VCR1] and that of the other pair to
[VCR2]. This will prevent interference between
the 2 pairs. (The default setting is [VCR1]. When
the button-type battery is replaced, the setting will
revert to the default [VCR1].)
1 Setting on the Camcorder:
Set [SETUP] >> [REMOTE] >> [VCR1] or
[VCR2].
2 Setting on the remote control:
[VCR1]:
Press [D] and [∫] simultaneously. 1
[VCR2]:
Press [E] and [∫] simultaneously. 2
ª
Concerning the button-type battery
≥When the button-type battery runs down,
replace it with a new battery (part number:
CR2025). The battery is normally expected to
last about 1 year, but it depends on operation
frequency.
≥Keep the button-type battery out of the reach of
children.
≥If the remote control mode of the Camcorder
and that of the remote control do not match with
each other, “REMOTE” will appear. When the
remote control is operated for the first time after
the Camcorder is turned on, “CHECK REMOTE
MODE” (
-67-) will appear and operation is
impossible. Set the same remote control mode.
≥The remote control is intended for indoor
operation. Outdoors or under strong light, the
Camcorder may not operate properly even
within the usable ranges.
Replace battery with Panasonic PART NO.
CR2025 only. Use of another battery may
present a risk of fire or explosion.
Caution: Battery may explode if mistreated.
Dispose of used battery promptly. Keep
away from children.
Do not recharge, disassemble or dispose of
in fire.
2 1
LSQT1091_ENG.book 27 ページ ２００６年１１月２７日 月曜日 午後１時１７分