Panasonic PV-GS320 Camcorder User Manual


 
Others
74
LSQT1091
ª About the AC adaptor
If the battery is warm, charging requires more
time than normal.
If the temperature of the battery is extremely
high or extremely low, the [CHARGE] lamp may
continue flashing and the battery may not be
charged. After the battery temperature has
decreased or increased sufficiently, recharging
starts automatically. So, wait for a while. If the
lamp still continues flashing even after the
recharging, the battery or AC adaptor may be
faulty. If so, please contact a dealer.
If you use the AC adaptor near a radio, radio
reception may be disturbed. Keep the AC
adaptor 1 m (3.3 feet) or more away from radio.
When using the AC adaptor, it may generate
whirring sounds. However, this is normal.
After use, be sure to pull out the AC cable from
the AC jack. (If they are left connected, a minute
amount of current is consumed.)
Always keep the electrodes of the AC adaptor
and battery clean.
ª
About the cassette
Never place the cassette in a high temperature
place.
The tape may be damaged, producing
mosaic-like noise at the time of playback.
When storing the cassette after use, be sure
to rewind the tape to the beginning and take it
out.
If the cassette is left for more than 6 months
(depending on the storage condition) in the
Camcorder or stopped midway, the tape may
sag and be damaged.
Once every 6 months, wind the tape to the end
and then rewind it to the beginning. If the
cassette is left for 1 year or longer without
winding or rewinding, the tape may be deformed
by expansion or shrinkage attributable to
temperature and humidity. The wound tape may
stick to itself.
Dust, direct sunlight (ultraviolet rays) and
humidity may damage the tape. Such usage
may cause damage to the Camcorder and the
heads.
After use, be sure to rewind the tape to the
beginning, put the cassette in the case to
protect it from dust and store it upright.
Keep the cassette away from strong
magnetism.
Apparatus using magnets such as magnetic
necklaces and toys have magnetic force that is
stronger than expected and they may erase the
contents of a recording or may increase noise.
ª
About the card
When inserting or removing the card, always
set the [OFF/ON] switch to [OFF].
When the access lamp is illuminated (During
access to the card), do not pull out the card,
rotate the mode dial, turn off the power or
cause any vibrations or impact.
Do not leave the card in places where there is
high temperature or direct sunlight or where
electromagnetic waves or static electricity are
easily generated. Moreover, do not fold or
drop the card.
The card may break or the contents of the card
may be destroyed or erased.
Do not touch the terminals on the back of the
card.
Electrical noise, static electricity or failure of the
Camcorder or the card may damage or erase
the data stored on the card. We recommend
saving important data on a personal computer
by using a USB cable, PC card adaptor and
USB reader/writer.
After use, be sure to remove the card from the
Camcorder for storage.
After use or when storing or carrying the card,
put it in the storage case.
Do not allow dust, water or foreign substances
to adhere to the terminals on the back of the
card. Moreover, do not touch the terminals with
your hand.
Keep the Memory Card out of reach of children
to prevent swallowing.
ª
Folder structure of the card
The folder structure of the card formatted by
the Camcorder will be displayed on the PC as
the illustration below.
Up to 999 pictures can be recorded on
100CDPFP folder etc.
Files with the DPOF settings can be recorded
on MISC folder.
256
LSQT1091_ENG.book 74 ページ 2006年11月27日 月曜日 午後1時17分