Filter
Top Products
Before using
20
LSQT1091
Inserting/removing a cassette
1
Fit the AC adaptor or the battery and turn on
the power.
2
Slide the [OPEN/EJECT] lever and open the
cassette cover.
≥When the cover is fully opened, the cassette
holder will come out.
3
After the cassette holder is opened, insert/
remove the cassette.
≥When inserting a cassette, orient it as shown
in the figure and then securely insert it as far
as it goes.
≥When removing, pull it straight out.
4
Push the [PUSH] mark
1
in order to close
the cassette holder.
≥The cassette holder is housed.
5
Only after the cassette holder is completely
housed, close the cassette cover tightly.
≥When inserting a previously recorded cassette,
use the blank search function to find the position
where you want to continue recording. If you are
overwriting a previously recorded cassette, be
sure to find the position where you want to
continue recording.
≥When closing the cassette cover, do not get
anything, such as a cable, caught in the cover.
≥After use, be sure to rewind the cassette
completely, remove it and put it in a case. Store
the case in an upright position. (
-74-)
≥If the indicator of the condensation does not
display on the LCD screen and/or EVF and you
notice condensation on the lens or the main
unit, do not open the cassette cover otherwise
condensation may be formed on the heads or
the cassette tape. (
-72-)
ª
When the cassette holder does not
come out
≥Close the cassette cover completely and then
open it again completely.
≥Check if the battery has run down.
ª
When the cassette holder cannot be
housed
≥Set the [OFF/ON] switch to [OFF], then to [ON]
again.
≥Check if the battery has run down.
ª
Accidental erasure prevention
If the accidental erasure prevention slider 1 of a
cassette is opened (slide in the direction of the
[SAVE] arrow), the cassette cannot be recorded.
When recording, close the accidental erasure
prevention slider of the cassette (slide in the
direction of the [REC] arrow).
Inserting/removing a card
Before inserting/removing a card, set the [OFF/
ON] switch to [OFF].
≥If the card is inserted or removed with the power
turned on, this Camcorder may malfunction or
the data recorded on the card may be lost.
1
Turn off the power
1
.
≥Check that the Status indicator has gone off.
2
Open the card slot cover.
OPEN/
EJECT
PUSH
1
R E C
SAVE
1
OFF
ON
1
LSQT1091_ENG.book 20 ページ ２００６年１１月２７日 月曜日 午後１時１７分