Panasonic PV-GS320 Camcorder User Manual


 
With a PC
58
LSQT1091
ª Installation of Quick Movie Magic/
MotionDV STUDIO
1
Insert the supplied CD-ROM into the
personal computer’s CD-ROM drive.
Quit all applications.
[Setup Menu] appears.
2 Click the [Quick Movie Magic]/
[MotionDV STUDIO].
3 Click [Next].
After reading the displayed contents, please
carry out the installation according to
instructions.
4 Select the Video system.
5 After the completion of setup, click on
[Finish].
Sample data is installed concurrently with the
Quick Movie Magic/MotionDV STUDIO
software.
6 Click [Finish].
ª
To start Quick Movie Magic or
MotionDV STUDIO
If you wish to capture data from a tape, set the
Camcorder to Tape Playback Mode and insert the
tape.
If you wish to capture images from the lens of the
Camcorder, set the Camcorder to the Tape
Recording Mode and remove the tape and the
card. (MotionDV STUDIO only)
About the PDF operating instructions for
Quick Movie Magic/MotionDV STUDIO
For details on how to use the software
applications, read the help file.
1 Set [start] >> [All Programs (Programs)] >>
[Panasonic] >> [Quick Movie Magic 1.0E] or
[MotionDV STUDIO 5.6E LE for DV] >>
[Manual (PDF format)].
Start Quick Movie Magic/MotionDV STUDIO
and select [Help] >> [Help] from the menu to
display the help file.
You will need Adobe Acrobat Reader 5.0 or
later to read the PDF operating instructions.
With USB cable (supplied)
OS:
Windows XP SP2
Windows 2000 SP4
The personal computer should be equipped with
an USB terminal (Hi-Speed USB (USB 2.0)
compliant) (A type).
Confirmation before connection
(for Windows 2000/XP)
When you connect the personal computer and the
Camcorder with the USB cable and then use
Quick Movie Magic or MotionDV STUDIO on
Windows XP SP2 or Windows 2000 SP4, check
the driver of the USB host controller.
It is required to use the driver for which
[Microsoft] is displayed on [Driver Provider] in
[Driver] tab.
1 Select [start] >> [Settings] >>
[Control Panel] to start [System].
[System Properties] is displayed.
2 Click [Hardware] tab and then click
[Device Manager] then
[Universal Serial Bus Controller].
3 Right-click [Enhanced Host Controller] and
then select [Properties].
LSQT1091_ENG.book 58 ページ 2006年11月27日 月曜日 午後1時17分