Filter
Top Products
. When not using the Lens Cap, pull the Lens Cap
Cord in the direction of the arrow. O
. When you are not recording_ be sure to cover the
Lens with the Lens Cap for protection. O
O'
. When you remove the Lens Cap, press the knobs
firmly.
We recommend that you attach the Shoulder Strap
before going out to avoid dropping the Camcorder.
1 Pull the end of the Shoulder Strap
through the Shoulder Strap Holder on the
Camcorder.
Fold the end of the Shoulder Strap, run
it through the Shoulder Strap Length
Adjuster, and pull it.
. Pull it out more than 1 inch (2 cm) Ofrom
the Shoulder Strap Length Adjuster so that it
cannot slip off.
. Attach the other end of the Shoulder Strap to
the other Shoulder Strap Holder in the same
way.
• Please use Genuine Panasonic DVC Tapes for
more information please contact your local dealer
or visit www.Danasonic.com.
• For your reference if you travel frequently you
should also purchase a Panasonic head cleaning
tape AY-DVMCLA and use when HEAD CLOG
message appears on the LCD/EVF of your
Camcorder.
1 Fit the AC Adaptor or the Battery and turn
on the Power.
2 Slide the [OPEN/EJECT] Lever toward the
front and pull up to fully open the Cassette
Compartment Cover.
• To protect the tape, if the cover is not fully
opened, the cassette holder cannot be ejected.
_EcTJ _
3 After the Cassette Holder is opened,
insert/remove a Cassette.
• When inserting a cassette_ orient it as shown in
the above, and then securely insert it as far as
it goes.
• When removing, pull it straight out.
Close the Cassette Holder by pressing the
[PUSH] mark @.
• The Cassette Holder is housed.
@
18