EdNng Mode
Still pictures can be recorded on the Memory Card
from scenes that have already been recorded on a
cassette.
1 Set the Mode Dial to Tape Playback Mode.
• The One-Touch Navigation icon is displayed
on the lower right of the screen.
lOne-Touch Navigation icon]
2 Insert a tape which already has recorded
contents and a card.
3 Move the Joystick Control [A] to start
playback and set the Camcorder to Still
Playback Mode at the scene you wish
to record, and press the [PHOTO SHOT]
Button.
• Audio will not be recorded.
Note:
. If you press the [PHOTO SHOT] Button without
pausing, blurred pictures may be recorded.
You can add music or narration to the recorded
Cassette.
. If the tape recorded in the [16bit] Mode is dubbed
with the Audio Dubbing function, the original sound
is erased. (If you wish to preserve the original
sound, use the [12bit] Mode when recording.)
. Audio Dubbing cannot be performed on a recording
made in LP Mode. (p. 29)
* Set to Tape Playback Mode.
1 Find a scene that you want to add sound
to, and press the [ la ] Button on the
Remote Control.
2 Press the [AUDIO DUB] Button on the
Remote Control.
. The [ hi]Ill]Ill]Indication appears.
3 To start Audio Dubbing, press the [ la ]
Button on the Remote Control. Or, move
the Joystick Control [A] to select [ o/_l1.
. The [ I_gll_®] Indication appears.
. Talk into the microphone.
4
Press the [mm] Button on the Remote
Control to stop audio dubbing. Or, move
the Joystick Control [A] to select [ e/il ]
again.
. The Camcorder is in the Still Playback Mode
again.
Before Recording with Audio Dubbing
. Set to Tape Recording Mode
. When you want to preserve the original sound
taken during recording, set [ _ ADVANCED]
>> [j_ AUDIO REC] >> [12bit] to take pictures.
(When set [16bit], the sounds taken during
recording are erased after recording with audio
dubbing.)
. Set [ _ BASIC] >> [_ REC SPEED] >> [SP] to
take pictures.
To Play Back the Sound Recorded by
12bit Audio Dubbing
Set [ _ SETUP] >> [_ 12bit AUDIO] >> [ST1],
[ST2] or [MIX].
ST1: It plays back only the obginal sound.
ST2: It plays back only the sound added by
Audio Dubbing.
MIX: It plays back both the original sound
and the sound added by Audio Dubbing
simultaneously.
, During Audio Dubbing, it is automatically set to
[ST2].
Notes:
• The blank section of a tape cannot be dubbed.
• Sounds sent through the DV terminal cannot be
dubbed.
• If a tape has a non-recorded portion when the tape
is dubbed, images and sounds may be disturbed
when this portion of the tape is played back.
• In the case of importing data recorded with Audio
Dubbing to a PC using the PC's software, only the
original sound (ST1) may be imported, depending
on the software.
rrl
o
o.
tb
53