Filter
Top Products
6
• The response speed of the liquid crystal display becomes slow at low
temperatures. This is due to the properties of the liquid crystal and
is not a fault.
• Periodic checks are recommended every 1 to 2 years in order to maintain
high performance.
• If the camera is subjected to rapid temperature changes, condensation
may form on the inside and outside of the camera. Therefore put the
camera in a bag or plastic bag, and take the camera out when the
difference in temperature has subsided.
• Refer to “Precautions When Using an SD Memory Card” (p.36) regarding
the SD Memory Card.
• Please note that formatting an SD Memory Card or the built-in memory will
delete all data; however it may still be possible to recover that data using
off-the-shelf data recovery software. Please manage your camera memory
at your own risk.
• Please do not press forcefully on the display. This could cause breakage
or malfunction.
• When using a tripod with the camera, be careful not to overtighten
the screw in the tripod socket on the camera.
• The AC plug cord supplied with the camera is for exclusive use with the
battery charger D-BC92. Do not use it with any other equipment.
• Storing the battery fully charged may decrease the battery performance.
Avoid storing it especially in high temperatures.
If the battery is left inserted and the camera is not used for a long time,
the battery will over-discharge and shorten the battery’s service life.
• Charging the battery a day before use or on the day of use is
recommended.
• Do not hold or force the extended part of the lens. This can cause
a malfunction.
e_kb484.book Page 6 Wednesday, March 18, 2009 5:23 PM