Filter
Top Products
97653976 F
Page 51
CONNECTING THE POWER CORD
To install the power cord on an LF 6600:
1) Ensure that an AC power cord is available and ready for installation. The type of AC power
cord being installed depends upon the installation location.
2) Ensure facility power is available and the AC power cord connector (male end) will match
the site AC power wall outlet.
3) Ensure that the AC power switch on the LF 6600 rear panel is set to the OFF ( O ) position.
4) Plug the AC power cord connector (female end) into the AC power receptacle on the LF
6600 rear panel.
5) Plug the AC power cord connector (male end) into a wall outlet.
CONNECTING MULTIPLE DEVICES
To install SCSI interface cables for a multiple-device configuration:
1) Ensure that the SCSI interface cables and a terminator (if required) are available and
ready for installation.
2) Plug one end of a SCSI interface cable into the vacant SCSI interface connector on the
previous device in the SCSI chain (see figure below). Plug the other end of the cable into
a SCSI connector.
3) If the LF 6600 is not the last unit in the daisy chain, plug one end of the other cable into the
vacant connector on the LF 6600 and then connect the other end of the cable to the next
SCSI device. Repeat this process until you reach the last SCSI device in the daisy chain.
If the LF 6600 is the last unit in the daisy chain, install a terminator on the LF 6600's vacant SCSI
connector.
4) Ensure that the SCSI bus is also terminated at the host adapter end.
The SCSI bus must be terminated at both ends in accordance with the LD 6100/LF 6600/LF
6602 SCSI Interface Specification (P/N 97653978).