Filter
Top Products
PLASMON LASER MAGNETIC STORAGE - LF 6600 User Manual
Page 54
RACK MOUNT CONFIGURATION DE-INSTALLATION
To de-install the LF 6600 Rack Mount configuration:
1) Remove the cabinet trim panel by grasping the panel at the top and pulling outwards. This
action pries the ball studs from the keeper holes.
2) Remove the right or left lateral Support Angle that anchors the Chassis to the adjacent
cabinet rail by unfastening the two M4 screws and optional standoffs. Remove other
fastening hardware anchoring the Support Angle to the rail.
3) Lift the slide releases and pull the LF 6600 all the way out of the cabinet.
WARNING
If two drives have been installed in the rack, ensure that only one
drive is extended at a time.
EP006057
Lift and Pull Slide Releases
SLIDE LOCKS
SLIDE RELEASES