Filter
Top Products
PLASMON LASER MAGNETIC STORAGE - LF 6600 User Manual
Page 62
CONFIGURATION MODE
Configuration mode is used to view and set drive operating parameters. The parameters that can be
configured and displayed are summarized in the following (the corresponding DOC display is shown in
parentheses).
Configuration mode can be entered when the "Ready" message is displayed on the DOC. To enter the
Configuration mode:
1) Press both the LOAD/MENU and TEST/SELECT switches simultaneously.
2) Verify that "View Config" is displayed.
Viewing the configuration ("View Config")
View the current operating parameters ("View Current")
View the firmware revisions of the drive ("View FW Revs")
View the hardware revisions of the drive ("View HW S/Ns")
View the hardware part numbers of the drive ("View HW P/Ns")
Setting the configuration of the operating parameters ("Set Config")
Set all parameters to the default value ("Set Defaults")
Set device SCSI identification number 0 through 7 ("SCSI ID:")
Enable or disable parity checking ("Parity:")
Set language option to English, French or German ("Language:")
Enable or disable write protect option ("Wrt Prot:")
Enable or disable media AutoLoad option ("AutoLoad:")
Enable or disable load switch option ("Load SW:")
Enable or disable read ahead ("Rd Ahead:")
Enable or disable Controller Detected Error blink option ("CDE Curs:")
Enable or disable Busy option ("Busy")
Enable or disable Mode Select Read Ahead ("ModSel RA")
Enable of disable Media Management Spin Up ("MM SpinUp")
Viewing diagnostic results or performing diagnostic operations ("Diagnostics")
Park the drive in preparation for shipment ("Park Drive")
Display the state of the drive sensors ("Test Sensors")
Clear the drive initialization variables in nonvolatile memory ("Clear NvRAM")
Allow Shuttle Calibration (“Cal Shuttle”)
Display controller detected error information ("View CDEs")
Enable or disable system event logging ("Sys Log:")
Set the extent of internal diagnostic test coverage ("Test Thru:")
View Real Time Performance Monitor ("View RTPM")
Clear RTPM error ("Clear RTPM")
Initialize DPC ("Init DPC")
Set the internal drive serial number ("Set Serial #")