Filter
Top Products
97653976 F
Page 73
SETTING THE MEDIA AUTOLOAD OPTION
The media AutoLoad load option enables a user to choose which media cartridge is automatically inserted
and loaded at power up and whenever the LOAD/MENU switch is pressed while in the Operating mode.
The factory default selects the cartridge in slot 1.
Perform the following procedure to set the LF 6600's AutoLoad option:
1) Enter the Configuration mode by pressing both the LOAD/MENU and TEST/SELECT
switches simultaneously.
2) Press the MENU switch until "Set Config" is displayed.
3) Press the SELECT switch to enter the Set Configuration menu.
4) Press the MENU switch until "AutoLoad:" is displayed.
5) Press the SELECT switch to scroll through the autoload options, (1,2,3,4,5,6,and MRU).
When the desired option is displayed, press MENU to enable that option and to move to
the next option in the Set Configuration menu.
6) Simultaneously press the LOAD/MENU and TEST/SELECT switches to exit the
Configuration mode. Simultaneously press the LOAD/MENU and TEST/SELECT
Switches again to move up to the Main menu.
SETTING THE LOAD SWITCH OPTION
The load switch option enables the user to enable or disable the LOAD/MENU switch on the DOC. The
LOAD/MENU switch can be disabled to prevent accidentally spinning down a media cartridge. This also
prevents cartridge loading from the DOC, giving the host exclusive control of media loading.
Perform the following procedure to enable or disable the LOAD/MENU switch.
1) Enter the Configuration mode by pressing both the LOAD/MENU and TEST/SELECT
switches simultaneously.
2) Press the MENU switch until "Set Config" is displayed.
3) Press the SELECT switch to enter the Set Configuration menu.
4) Press the MENU switch until "Load SW:" is displayed.
5) Press the SELECT switch to scroll through the states for the load switch (on, off). When
the desired state is displayed, press MENU to enter the state and move to the next
option in the Set Configuration menu.
6) Simultaneously press the LOAD/MENU and TEST/SELECT switches to exit the
Configuration mode. Simultaneously press the LOAD/MENU and TEST/SELECT
Switches again to move up to the Main menu.