Filter
Top Products
52
PDC 700 Digital Camera Troubleshooting
Problem Solution
The Polaroid PhotoMAX Image
Maker Software does not see the
camera
• Make sure you turn on the camera
and then your turn on your
computer.
• Close the PhotoMAX Image
Maker Software, turn on the
camera, and then open the
software again.
• Connect the PDC 700 Digital
Camera serial cable to the RS-
232C serial port on the back of the
computer and connect the other
end of the cable to the serial cable
port on the camera.
• Make sure the AC power adapter
is connected to the power socket
on the camera and to an outlet.
• Make sure the cables are attached
firmly to the camera and to the
back of the computer.
No power
• Slide the power button to the right.
• Position the + and - terminals
correctly in the battery
compartment.
• Replace the batteries.
• Use the recommended AC adapter.
Low Battery indicator on the
Status panel
Replace the batteries.