Filter
Top Products
53
Cannot take a picture
• Wait until the green LED next
to the optical viewfinder stops
blinking.
• If you have taken the
maximum number of images,
transfer the images to your
computer and delete the
images from memory.
• Make sure the memory card is
inserted correctly in the
memory compartment.
• If the camera is connected to
your computer, use the
software controls to take a
picture, or disconnect the
camera from the computer.
Flash does not work
• Check the flash mode icon on
the Status panel. Cycle through
the flash options to turn on the
flash if it was disabled.
• Wait until the green LED next
to the optical viewfinder stops
blinking.
• Replace the batteries.
No signal on the TV monitor while
the camera is on
Use the specified cable to connect the
camera and the TV monitor.