Filter
Top Products
Hollywood DV-Bridge User’s Guide • Using Hollywood DV-Bridge With a Macintosh • Page 41
Connecting the TV monitor to the camcorder or VCR results in the configuration shown
below
IMPORTANT: Make sure that the camcorder or VCR and monitor are set up properly to
receive a video signal. It might be necessary to set a camcorder to VTR mode, while a
VCR or monitor might need to be set to “Line In,” “L1,” “L2,” “Aux” or a similar channel.
Or, if a monitor is connected to a VCR with a coaxial cable, you might need to set the
monitor to channel 3 or 4. Check each device’s documentation for specific details.
TV
Optional
P
review Monitor
VHS
Audio In
Audio Out
RCA Video In RCA Video Out
S-Video In
S-Video Out
Or
Coaxial In Coaxial Out
OR
Hollywood DV-Bridge
Audio In Audio Out
RCA Video In
RCA Video Out
S-Video In
S-Video Out
Or
(To AC Power)
Back