Filter
Top Products
Hollywood DV-Bridge User’s Guide • Using Hollywood DV-Bridge Without a Computer • Page 59
Copying DV to DV
1. Use the Mode Selector button on the back of the Hollywood DV-Bridge to change the
mode to Pass Through.
The LED indicators on the front of the unit show the active mode (see the illustration
below).
If you are using a camcorder as your input (source) device, put it into Video Tape
Recorder mode. Cue the tape to the spot where you want to start playing.
If you are using a camcorder as your output (target) device, put it into Video Tape
Recorder mode. Cue the tape to the spot where you want to start recording. Make sure
you do not record over existing footage on the tape that you want to keep.
2. Press the Play button on the source camcorder or VCR, and press the Record button
on the target camcorder or VCR.