Filter
Top Products
112
Cause and/or Corrective Action
•The START/STOP MODE switch is set to 5 SEC or .
m Set it to . (p.53)
•The battery is dead.
m Use a charged battery pack or the AC power adaptor. (p.8, 29)
•Moisture condensation has occurred.
m Remove the cassette and leave the camcorder for at least 1
hour. (p.106)
•You pressed DATE and TIME together for more than 2 seconds.
m The camcorder is not malfunctioning. You may start recording.
Flashing will stop soon.
•The lithium battery is weak or dead.
m Replace the lithium battery with a new one. (p.96)
•The POWER switch is set to CAMERA or OFF.
m Set it to VTR.
•The tape has run out.
m Rewind the tape or use a new one. (p.23)
•Reset the date and time. (p.97)
•STEADY SHOT is set to OFF.
m Set STEADY SHOT to ON. (p.59)
•FOCUS is set to MANUAL.
m Set it to AUTO. (p.63)
•Shooting conditions are not suitable for autofocus.
m Set FOCUS to MANUAL to focus manually. (p.63)
•START/STOP MODE is set to 5 SEC or .
m Set it to . (p.53)
•A title is displayed.
m Stop superimposing the title. (p.54)
•The stereo tape is played back with HiFi SOUND set to 1 or 2 in
the menu system.
m Set to STEREO in the menu system. (p.34)
•The picture has been recorded with WIND set to ON in the menu
system.
m When there is no wind, set it to OFF. (p.32)
Trouble check
Operation
Symptom
Recording stops in a few seconds.
The cassette cannot be removed
from the holder.
{ and 6 indicators flash and no
function except for cassette
ejection works.
The counter, date, or time
indicator is flashing.
The tape does not move when a
tape transport button is pressed.
The date or time indicator
disappears.
The Steady Shot function does not
activate.
The autofocusing function does
not work.
The fader function does not work.
No sound or only a low sound is
heard when playing back a tape.
Excessive high-pitched sound is
heard.