Sony DNW-90/90P Camcorder User Manual


 
Chapter 4 Adjustments and Settings for Recording 4-47
4
4-7-2 Setting the Indicator
Select the items to be indicated by the indicator from the ‘!’ LED
page of the setup menu. Note that at the factory the ‘!’ page is not set for
display. To access the ‘!’ LED page, either set the camcorder to engineer
mode, or select the ‘!’ LED page from the MENU SELECT page before
use.
See Section 4-6-1 “Setup Menu Configuration” (page 4-37) for more information
about the engineer mode and selecting the display page.
Follow the procedure below to set the indicator.
Setting the indicator
1 Set the MENU ON/OFF/PAGE switch to ON.
The display for setting the status disappears from the viewfinder
screen, and the page that was on the screen when the last menu
operation ended appears.
(When this menu is first used, the lowest-numbered page of the
currently selected pages for configuring the menu appears.)
(Continued)
2,4,5
1,2,6
3