Filter
Top Products
Chapter 2 Locations and Functions of Parts and Controls 2-21
2
!∞ GAIN selector
This selector switches the gain of the video amplifier to match the
lighting conditions during shooting. The gains corresponding to the L, M,
and H settings are selected from the setup menu before use. The factory
settings are L = 0 dB, M = 9 dB, and H = 18 dB.
Note that if the display mode is set to 3 when this selector is adjusted, the
new setting will be indicated on the setting change/adjustment progress
message display area of the viewfinder screen for about 3 seconds (e.g.
GAIN: 12 dB).
For information about setting the gain values, see Section 4-9-1 “Setting the GAIN
Selector Values” (page 4-74).
!§ AUTO W/B BAL (automatic white/black balance adjustment)
switch
This switch activates the adjustment functions of the white balance and
black balance.
WHT: Automatic adjustment of the white balance. If the WHITE BAL
switch is set to A or B, the white balance setting is stored in the
corresponding memory. When the ATW setting is selected in the setup
menu, the white balance setting adjusted with this switch is not stored
in memory.
BLK: Automatic adjustment of the black set and the black balance. The
setting is stored in a separate memory.
!¶ SHUTTER selector
Set this selector to ON to use the electronic shutter. Set it to SEL to
switch the shutter speed or mode setting within the range that has been
previously set from the setup menu.
Note that if the display mode is set to 2 or 3 when this selector is adjusted,
the new setting will be indicated on the setting change/adjustment
progress message display area of the viewfinder screen for about 3
seconds (e.g.:SS: 1/250 or :CLS: 60.6 Hz).
For more information about the shutter speed and mode settings, see Section 4-2
“Setting the Electronic Shutter” (page 4-11).