Filter
Top Products
4-14 Chapter 4 Adjustments and Settings for Recording
4
1/100 (or 1/60) 1/20001/10001/5001/2501/125
The current shutter setting appears for about 3 seconds in the setting
change and adjustment progress message display area of the
viewfinder screen.
E.g.: SS : 1/250 or : CLS : 60.6 Hz
3 Before the message from step 2 disappears, push the SHUTTER
selector to SEL again and repeat until the desired mode or speed
appears.
Pushing the SHUTTER selector to SEL repeatedly allows you to
cycle through the settings of mode and speed preselected on the
SHUTTER SPEED page of the setup menu.
Note that all modes and all standard-mode speeds listed in the table
on page 4-12 are preselected using the SHUTTER SPEED page of
the setup menu.
For more information about the SHUTTER SPEED page, see “Changing the
range of choice of shutter mode and speed settings” (page 4-17).
Selectable settings of shutter mode and speed (factory setting)
Once a shutter speed is selected, it is maintained until the next shutter
speed setting operation.
When the message “STORED DATA:NG” appears, the shutter speed
returns to 1/100 s (DNW-7/90/90WS/9WS) or 1/60 s (DNW-7P/90P/
90WSP/9WSP).
CLS/ECS mode
a)
EVS mode
a) Either CLS mode or ECS mode (DNW-90/90P/90WS/90WSP only) is
selected depending on the shutter speed set in the setup menu CLEAR
SCAN page.
Standard mode