Filter
Top Products
Chapter 2 Locations and Functions of Parts and Controls 2-27
2
2 Rotary encoder
When the cursor is aligned with the page title of a setup menu, pressing
the rotary encoder changes to the page switching mode. When the cursor
is other than on the page title, pressing the rotary encoder switches to the
mode in which you can change the value of the current menu setting.
To change the page or vary a setting value, turn the rotary encoder.
3 MENU ON/OFF/PAGE (menu display/paging) switch
This switch is used to display the setup menu on the viewfinder screen or
the test signal screen and to page through the menu items.
ON: Displays the setup menu on the viewfinder screen or the test signal
screen, at the page which was on the screen when the previous menu
access ended.(When the menu is first used, the first page is displayed.)
To enable the MENU CANCEL/PRST/ITEM switch, select this
position.
OFF: Removes the setup menu from the viewfinder screen or the test
signal screen.
PAGE: Every time this switch is pushed down from the ON position, the
next page of the setup menu is displayed.
4 MENU CANCEL/PRST/ITEM (menu setting cancellation/menu
presetting/item selection) switch
When the MENU ON/OFF/PAGE switch is set to ON, this switch is
used to select an item on the setup menu or erase shot ID characters.
CANCEL/PRST: Pushing the switch up to this position allows you to
cancel the previous settings, to reset the settings to their initial values,
or to erase shot ID characters.
ITEM: Every time the switch is pushed down to this position, the cursor
(arrow mark) in the page moves to the next item.
Note
Operation depends on the items displayed. Check the menu operation
that corresponds to the current item for details.