Filter
Top Products
Chapter 4 Adjustments and Settings for Recording 4-71
4
The last page accessed appears in the viewfinder display. When this
menu is first used, the lowest-numbered on of the currently selected
pages appears.
2 Press the MENU ON/OFF/PAGE switch toward the PAGE position
(or use the rotary encoder) until the OPERATION MODE 2/2 page
appears, as shown below.
3 Push the MENU CANCEL/PRST/ITEM switch toward the ITEM
position.
Next press the rotary encoder, to display a question mark to the left
of “TIME CODE DISP”.
4 Turn the rotary encoder to select whether or not to display or output
the time code and other information.
To display or output the information: turn the rotary encoder
counterclockwise as seen from the front of the camera to select
one of the following settings.
• VF: display in the viewfinder.
• TEST: output from the TEST OUT connector.
• BOTH: display in the viewfinder and output from the TEST
OUT connector.
(Continued)
∗
OPERATION MODE 2/2
∗
TIME CODE DISP : OFF