Filter
Top Products
4-38 Chapter 4 Adjustments and Settings for Recording
4
Note
When the camcorder is connected to a remote control unit and is being
controlled remotely, the SHUTTER SPEED, SETUP CARD, and
LEVEL 5 / 9 pages and several pages of the engineer-oriented menu
(AUTO SHADING, DCC ADJUSTMENT, MEASUREMENT MODE,
and DATA RESET pages) are not displayed.
For information about the function of each page, refer to the relevant sections in
this manual or the Maintenance Manual.
When changing the setup menu
You can configure the setup menu to display only the pages you need.
To select pages, use the MENU SELECT page of the engineer-oriented
menu. When using the engineer-oriented menu, switch the camcorder to
engineer mode (it is factory set in user mode). With the power of the
camcorder off, open the plate on the right-hand side of the body, flip the
switch on the side of the AT-84 board, reattach the plate to the body,
then turn on the power again.
Engineer mode and user mode differ in the following ways.
Engineer mode : All the pages in the setup menu can be used. Data set
with the menu is written to non-volatile memory and can be stored
semi-permanently.
User mode : Only selected user-oriented pages (pages 1 to 21) can be
used. Data set with the menu is stored for about one week.
After making settings and adjustments in engineer mode, configure the
setup menu with the pages you use frequently so that you can access
them quickly.
Refer to the Maintenance Manual for information about the internal switches and
the MENU SELECT page.