Filter
Top Products
4-72 Chapter 4 Adjustments and Settings for Recording
4
4-9-3 Selecting the Test Output
Use the TEST OUT page of the setup menu to select the type of video
signal to be output from the TEST OUT connector.
Selecting the test output
Follow the procedure below to select the test output signal.
Selecting the test output
1 Set the MENU ON / OFF / PAGE switch to ON.
The page that was on the screen when the last menu operation ended
appears on the viewfinder screen. (When this menu is first used, the
lowest-numbered page of the currently selected pages for
configuring the menu appears.)
2 Push the MENU ON / OFF / PAGE switch repeatedly to PAGE until
the TEST OUT page shown on the next page appears (or use the
PAGE + UP / DOWN function).