Filter
Top Products
38
Setting the Camera Outputs
Chapter 3 Basic Adjustments and Settings
1) The VBS output signal always becomes the camera image to which ITU-
R709 gamma is applied.
2) With fixed gamma, the Detail settings for the main line are not applied.
The fixed pedestal and knee levels are applied.
When power saving is not activated for VBS, S23.98PsF/23.98PsF is
pulled down to 59.94i and S24PsF/24PsF is pulled down to 50i then
output, so that the camera image can be displayed on the viewfinder or a
monitor that does not support 23.98PsF/24PsF.
3) When MONI GAMMA ENABLE is set to OFF, the same gamma as that
applied to the main line is applied to all the outputs. However, the PB and
PB MIX modes can be independently selected for the VF, MONI, and VBS
signals.
3-5-3 Outputting Color Bars
The color-bar signal can be output by setting the color-bar
generator built in the camera to ON.
The color-bar generator can be turned ON or OFF on the
<OTHERS 1> page of the USER (MAINTENANCE)
menu.
<OTHERS 1> page
When CAM BARS is set to ON, the color-bar generator is
turned ON, and the color-bar signal is output.
The color-bar signal is not output with the video output
from the VF1, VF2, MONITOR OUT HD SDI 1/2, and
REMOTE connectors if fixed gamma (R709) is selected
for MONITOR GAMMA of the respective output on the
<PB/MONI GAMMA> page (except when a VBS signal is
output).
PB
POSITION
RIGHT With HOR, the playback picture
is displayed on the right and the
camera image on the left.
(Default when HOR is selected)
LEFT With HOR, the playback picture
is displayed on the left and the
camera image on the right.
BOTTOM With VERT, the playback picture
is displayed in the lower part
and the camera image in the
upper part. (Default when VERT
is selected)
TOP With VERT, the playback picture
is displayed in the upper part
and the camera image in the
lower part.
BOUNDARY With HOR:
0-1920
With VERT:
0-1080
The boundary position can be
changed. (Default: with HOR:
960, with VERT: 540)
Note
Item Setting Content
<OTHERS 1> U21
FAN MODE : AUTO1
CAM BARS :
B
ON
IMAGE INVERT : OFF