Filter
Top Products
Audio dubbing
Choose a connection described on the previous pages, and connect audio equipment or
microphone to your camcorder. Then follow the procedure below.
(1) Instal the recorded tape into your camcorder.
(2) Set the POWER switch to VCR on your camcorder.
(3) Locate the recording stml point by pressing _. Then press n at the point
where you want to start recording to set your camcorder to the playback pause
mode.
(4) Press AUDIO DUB _. The green _ II indicator appears on screen.
(5) Press II on your camcorder and sta_l playing back the audio you want to
record at the same time.
The new sound is recorded in stereo 2 (ST2) during playback. During
recording new- sound, the red _ appears on the screen.
(6) Press • on your camcorder at the point where you want to stop recording.
AUDIO DUB
To add audio more precisely
Press ZERO SET MEMORY on the Remote Commander at the point where you want to
stop recording later in tile playback mode.
CarLy out steps 3 to 5. Recording automatically stops at the point where ZERO SET
MEMORY was pressed.
(1) Play back the tape on which you added audio.
(2) Press MENU, then select AUDIO MIX in _1_ with the SEL/PUSH EXEC dial
(p. 178).
96
(3) Turn the SEL/PUSH EXEC dial to adjust the balance between the original
sound (STI) and the new sound (ST2), then press the dial.
Five minutes after you disconnect the power supply or remove the battery
pack, the AUDIO MIX setting returns to original sound (ST1) only. The default
setting is original sound only.