Filter
Top Products
TOSHIBA Network Camera - IK-WB15A - SDK (Ver 1.00.SC)
©TOSHIBA Corp. Appendix.A
127
As compared with the normal status, this status is characterized by the following two points:
- There is no <<image fields>>.
- The “stream” message (<stream msg>) is added together with the Length indicating line before the stream termination message of
“EndOf-getstream.cgi”.
--- Contents of <stream msg> ---
<stream msg> is a message to be used to notify the client of a streaming execution result and its length is fixed to 20 bytes
in every
message. This is used not only to notify an error message but to notify a streaming forced termination status such as abort5/abort10.
“EndOf-getstream.cgi” is a part of <stream msg> and a message that is always output when streaming ends.
Next, the types of <stream msg> message and the output timing of these messages are described below.
Item No. Message type contents of message Status Note
1. Normal-1 OUT
(streaming exec task/abort exec task)
EndOf-getstream.cgi. both normal and error This message may always be output with the
exception of abort10.
2. Normal-2 OUT
(streaming exec task)
Not Found........... normal The last data has been distributed at reproduced
image stream distribution.
3. Error-1 OUT
(streaming exec task)
Parameter Error..... error An error has found in an input parameter to the
stream.
4. Error-2 OUT
(streaming exec task)
unmatch auth info... error The ID/PW authentication information does not
match. In the IK-WB15A. This error is not notified.
5. Emergency Normal-1 OUT
(streaming exec task)
Abort............... normal Stream distribution has been forcibly terminated by
an abort5/10 request.