Filter
Top Products
23
Outline Diagram
Unit (mm)
Bench Operation
A fan cools the electronic load by drawing air through the button and sides and exhausting it out the back.
Minimum clearances for bench operation are 25 mm along the sides.
CAUTION
Do not block the fan exhaust at the rear of the Load.
Input Connections
Power Cord
Connect the power cord to the IEC 320 connector on the rear of the unit.
WARNING
SHOCK HAZARD:
the power cord provides a chassis ground through a third conductor. Be certain that your power
outlet is of the three-conductor type with the correct pin connected to earth ground.
NOTE
The detachable power cord may be used as an emergency disconnecting device. Removing the power cord from the
ac input connector will disconnect ac input power to the unit.