Filter
Top Products
25
6.Press
△▽
0.000W I: 0.000A
Display the actual power value and
setting value.
In Case of Trouble
Should the power-on self test of the Electronic Load fail, you may try the following: When turning on the power, make
sure the power cord to the unit is plugged in and the power switch is in the on position.
1) Check the power voltage setting.
Work voltage of load have two type 110V or 220V , Please make sure it is right voltage accordance to the voltage
in your area. You could change the voltage setting through dial the switch in the rear panel.
2) Check the fuse.
If fuse is blown, please replace it according to the following specification.
Model Fuse specification
(110VAC)
Fuse specification
(220VAC)
8510 T0.5A 250V T0.3A 250V
3) Location of Fuse
Front Panel Operation
Display
16-character fluorescent display for showing measurements and programmed values.
Front Panel Display
Indicators for operating modes and status conditions:
OFF
power off
Trigger
Indicates that the electronic load is waiting an
initiate and trigger to occur.
CC
The selected input channel is in the
constant current (CC) mode.
Sense
Indicates that the electronic load is in sense
state
CV
The selected input channel is in the
constant voltage (CV) mode.
Error
A errors have occurred
CW
The selected input channel is in the
constant power (CW) mode.
Link
In the communication state
Fuse