Filter
Top Products
7Printer Parts and Their Functions
3 Press the ON/OFF button to turn the printer on.
The Power lamp flashes, then changes to steady (non-flashing).
The HOME screen appears on the LCD.
Turning Off the Printer
Check the following before turning off the printer.
z The Access lamp of the memory card is not flashing.
z The printer is not operating.
1 Turn off the printer by pressing the ON/OFF button.
The Power lamp goes out and the power will be turned off.
Push down the LCD Monitor.
2 Close the Paper Feed Tray and then the Paper Output Tray.
Screen-saver mode
If you leave the printer more than about 5 minutes without using any button on
the operation panel when the printer is turned on, the LCD goes into Screen-
saver mode automatically.
Press the OK button to resume the LCD.
Note
If the Alarm lamp is lit orange and an error message is displayed on the LCD, see
“Error Message Is Displayed on the LCD” on page 35.
Important
The Access lamp flashes while the printer is reading or writing data from/to the
memory card. Removing the memory card or turning off the printer while the
Access lamp is flashing may damage the data saved on the memory card.
Note
Power cord
Before unplugging the power cord, turn off the printer and ensure that the Power
lamp has gone out. You may not be able to print afterward if you unplug the power
cord when the Power lamp is lit or flashing.
Note
When using the optional battery, the printer will be turned off automatically after
about 5 minutes from when the LCD goes into Screen-saver mode.
Access lamp