Filter
Top Products
34
7
5
6
LAN
cable
Hub
Enter the user name and password.
User name: root (default setting)
Password: VB101 (default setting)
The user name and password can be
changed on the System Setting page.
(→ P.39)
Launch the browser and enter the
following URL:
http://192.168.100.1/admin/
The Settings Title Page is displayed.
2
1
3
Settings Title Page
Remove the RS-232C cable connected to the PC used for
initial setup and connect the LAN cable.
When you connect a LAN cable, turn off the VB101 power. After connecting the LAN
cable, turn the VB101's power on.
c
Note
The IP address "192.168.100.1" is given as an example. However, the actual IP
address must be changed to match your system settings.
Initial Setup
Follow steps - below to launch the browser and enter
your user name and password.
Use the video cable and the RS-232C cable to connect the
camera to the VB101.
Connect the VC-C4 camera with the video cable to video input socket V1 on the VB101. Next,
use the RS-232C cable to connect the camera to the camera control connector CC1.
After connecting the camera, turn on the power switch on the camera.
c
Note
● Before check the operation, install the Web browser on your PC.
● To restore the factory default settings, refer to page 160 in the appendix.