Filter
Top Products
40
Ethernet
The same settings can be specified on the
Basic Settings settings page.
"Use Ethernet"
Tick this checkbox to use Ethernet.
"Address Setting Method"
If you select "Auto Setting (Bootp)", the IP
address is automatically acquired by the
Bootp server after restart. If you select
"Manual Setting", enter the IP address
and subnet mask also.
"Give priority to Bootp option when
deciding subnet mask."
If you tick this option, the subnet mask
specified by the Bootp server is given
priority over the subnet mask address
specified below when "Auto Setting
(Bootp)" is selected as the address
setting method.
"Give priority to Bootp option when
deciding gateway address."
If you tick this option, the gateway
address specified by the Bootp server is
given priority over the default gateway
address specified below when "Auto
Setting (Bootp)" is selected as the
address setting method.
"IP Address"
Enter a network interface-specific IP
address.
"Subnet Mask"
Enter the subnet mask specified for the
network to be connected.
If you selected "Auto Setting (Bootp)" as
the address setting method, check that
the Bootp server has been started up.
Contact the network administrator for the
IP address, subnet mask, and default
gateway address settings.
Network Settings Page
Use this page to specify the settings for connecting to an Ethernet or PPP network.
For a LAN connection, specify Ethernet settings. For connections made with a modem, specify
PPP settings.
Detail Settings
c
Note
● If you are using Ethernet, take particular care with the IP address, subnet mask
and route settings. If any of these items an error, you may be completely unable
to access the VB101 via Ethernet and it may only be possible to recover the
problem by using the initial setup tools to correct the error.
● Turn the VB101 off before you insert a modem card.
● When you change an IP address, please re-access the Settings Title Page
with the new IP address (→ P.36).