Filter
Top Products
Setup Procedures
3
37
"Japanese" button
Click this button to display the settings page
in Japanese. The button then changes to
"English" and switches the display back to
English when clicked.
"Send Config. and Reboot VB101." button
After you have changed the settings on a
page, click the "OK" button on that page.
This returns you to the title page. At that
point, the changes have not been sent to the
VB101. Clicking this button confirms the
changes, writes them into the VB101
memory and automatically restarts the
VB101 to validate the changes. If the
changes do not require restarting, the "Send
Config. to VB101" button is displayed
instead of this button.
"Restore to previous VB101 Config" button
Click this button when you want to cancel
the changes you have made to the settings
page. All the changes are discarded and
returns to its previous values.
If no settings have been changed, these 2
buttons are not displayed.
Clicking on the titles displays
each setting pages.
Detail Settings
Settings Title Page for VB101
Those settings that require the VB101 to
be restarted for the changes to take effect
are marked with a red tick.
e
Tip
Click the [OK] button when you have changed the settings. To discard the
changes, click the [Cancel] button. You are then returned to the settings title page.
Settings Title Page
The various settings on the VB101 are specified by using a browser to access Web pages on the
VB101. From this title page, you can move to each settings pages and confirm the changes to the
settings, write the changes to the VB101 memory and perform restarts.
c
Note
● Do not open multiple browser windows at the same time to change settings
in parallel.
● Do not use the "Back" and "Forward" buttons in your browser to move
between settings pages. Due to the effects of caching, there are
possibilities that an old settings page will appear, settings will return to
their original values, or unintended changes will occur.
● When you change the settings, you should always click the "Send Config.
to VB101", or the "Send Config. and Reboot VB101" button.