Filter
Top Products
44
"Camera Control Port"
Select the camera control connector (→ P.
22) to which the camera is connected.
Select "Not controlled" for cameras that
are not connected or not controlled.
"Cascade Number"
If cameras are cascade connected, select
numbers assigned to the cameras.
Numbers in ascerding order from 1 are
assigned to each camera starting with the
first camera connected to camera control
connector CC1 and CC2.
"Home Position"
This is the standard camera position used
for picture recording, etc.
"Pan"
Sets the pan position of the camera.
"Tilt"
Sets the tilt position of the camera.
"Zoom"
Sets the value for the camera's angle of
zoom.
"Brightness"
Sets the target value for the camera's
auto exposure feature. Select "Brighter "
if the picture is darker due to backlight
or other factor.
"Shutter speed "
Sets the camera shutter speed. Select
Auto, 1/60 or 1/100.
"Focus Mode"
Sets the focusing mode for the camera.
Select "Auto" (auto focus), "Auto (for
domes)", or "Fixed at infinity" (focus
fixed at infinity).
"View Restriction"
If you tick the "Apply View restriction" option, the settings below are
enabled. Use this setting to prevent clients from seeing certain
camera angles. Using the VB Administration Tools is a
convenient way to set the view restrictions (→ P.73).
"Upper value, Lower value, Left value, Right value"
Sets the extent of the field of view provided to users.
(Specify settings so that the upper value is greater than the lower
value and the left value is less than the right value.)
"Telephoto, Wide-angle"
Sets the zoom angles provided to users.
(Specify settings so that the telephoto setting is less than or equal
to the wide-angle setting.)
Detail Settings
Click the [OK] button to change the settings. To discard the changes, click the
[Cancel] button. This returns you to the settings title page.
● View restrictions can be set visually and more easily from the VB
Administration Tools. Please use the VB Administration Tools for the
settings (→ P.73).
● When the VC-C4/VC-C4R are used in combination with an outdoor housing,
set Focus Mode to "Auto (for domes)," in order to avoid focusing on the
wall of the outdoor housing.
e
Tip