Filter
Top Products
Setup Procedures
3
43
Common Settings
"Main Camera"
Specifies the camera selected when the
VB101 starts up.
"Baud rate of camera control port CC1/CC2"
For CC1 and CC2, select the same baud
rate as that set on the camera.
On the VC-C4/VC-C4R, the default setting
is 9600.There is basically no need to
change this.
"Return to Home Position when nobody has a
control privilege"
The camera is moved to its home position
if there is no request for a control
privilege. (→ P.44)
Settings for cameras 1 to 4
The camera1 to 4 correspond to cameras
which are connected to V1 to V4.
"Use this Camera"
When you tick this option, this camera is
used and the settings below are enabled.
"Camera Name"
Used in the camera selection bar in the
WebView Livescope Viewer.
"Wide Converter"
Always select "Used" when a wide-angle
converter is mounted on the camera.
"Video Signal"
Select Auto Detect, NTSC or PAL.
"Video Capture Size"
The available settings are 640x240,
320x240 and 160x120.
"Video Quality"
Enter an integer between 1 and 99. The
greater the value, the better the quality.
However, since picture data will also be
larger, higher-quality pictures may lower
the frame rate.
Camera and Video Settings Page
Use this page to set the camera control parameters and the video capture size and quality.
Using the VB Administration Tools is a convenient way to set the view restrictions (→ P.
73).
Detail Settings