Filter
Top Products
12
2-2 Audio (input) Function Section
MIC IN (microphone input) jack (XLR, 3-pin)
A microphone (optional accessory) is connected here.
Power for the microphone comes from this jack.
A remote microphone may be connected. In this case, the
power supply to the appropriate connector must be enabled
through menu option FRONT MIC POWER or REAR MIC
POWER.
These options are found in the <MIC/AUDIO2> screen on
the MAIN OPERATION page.
A stereo microphone may be connected, but you will need to
replace the connector. For more information, contact your
distributor or designated service provider.
AUDIO LEVEL CH1/CH2 (audio channel 1 & 2
recording level adjustment) controls
With the AUDIO SELECT CH1/CH2 switch positioned to
[MAN], these controls can be used to adjust the recording
levels for Audio Channels 1/2.
Note that the controls are designed to be locked. For
adjustment, each control must be depressed while turning.
AUDIO SELECT CH1/CH2 (audio channel 1 & 2 automatic/
manual level adjustment selector) switch
Use this switch to select recording level control mode for
Audio Channels 1 and 2.
AUTO: Recording level automatically controlled.
MAN: Recording level manually controlled.
AUDIO IN (audio input selector) switch
Use this switch to select the signals recorded through Audio
Channels 1 - 4.
FRONT: Signal from the microphone connected to the
MIC IN jack is recorded.
W.L. (WIRELESS)
Signal from the slot-in wireless receiver is
recorded.
REAR: Signal from the audio device connected to the
AUDIO IN CH1/CH2 connector is recorded.
<Note>
When you use stereo microphone (AJ-MC900G optional),
set both CH1 and CH2 to [FRONT]. The signal from L CH is
recorded to CH1 and that from R CH to CH2.
AUDIO IN CH1/CH2 (audio input channel 1 & 2)
connectors (XLR, 3-pin)
Audio devices or a microphone may be connected here.
LINE/MIC/+48V (line input/mic input/mic input +
48V) selector switch
Used to select the audio signal input from the AUDIO IN
CH1/CH2 connectors.
LINE: Audio signal line-input from the audio device is
input.
MIC: Audio signal from a self-powered (active)
microphone is input. (The main unit does not
supply power to the remote microphone).
+ 48V: Audio signal from a passive microphone is input.
(The unit supplies power to the remote
microphone).
Wireless slot
A Unislot
®
wireless receiver (optional accessory) may be
attached here.
FRONT AUDIO LEVEL (audio recording level
adjustment) control
This control adjusts the recording levels for Audio Channels
1 and 2. Level adjustment does not depend on the position
of the AUDIO SELECT switch.
The control can be enabled or disabled through the menu
options FRONT VR CH1 or FRONT VR CH2. These options
can be found in the <MIC/AUDIO1> screen on the MAIN
OPERATION page.