Filter
Top Products
65
5
When using a BP-90 type battery pack.
1 Remove the battery holder.
2 Attaching the battery case to the camera-recorder.
Connect the cable on the camera-recorder to the cable
on the battery case (BP-90 type).
Using a screwdriver, secure the battery case (BP-90
type) to the camera-recorder.
Open the cover and lift the rubber cap so that the screw
tightening hole is visible. Tighten the screws to secure
the battery case to the camera-recorder. Be sure to fully
tighten the screws.
<Notes>
z Do not use excess force when lifting the rubber caps
forcibly.
z Take special care not to pinch the cable.
3 Connect the battery pack plug to the socket inside the
battery case, and insert the battery pack into the case.
<Note>
Make sure you turn OFF the camera-recorder power before
connecting or disconnecting the plug.
4 Setting the battery type.
Select the battery type listed under BATTERY SELECT.
Select BATTERY SELECT from the <BATTERY/P2CARD>
screen on the MAIN OPERATION page.
Please refer to [8-6-2 BATTERY SETTING1] for more
information.
Battery holder
Connect Battery Case
(For BP-90 type)
Label
surface