Filter
Top Products
67
5
5-1-2 Using an AC Power Supply
When using the Panasonic AJ-B75 AC adapter
1 Plug the AJ-B75 DC OUT connector into the camera-
recorder’s external DC input socket.
2 Turn the AC adapter power ON.
3 Turn the camera-recorder power switch ON.
<Notes>
z When both the battery pack and AC adapter are
connected, power is supplied from the AC adapter. The
battery can be removed or mounted while using the AC
adapter.
z When using the AC adapter, make sure you turn ON the
AC adapter power before turning ON the camera-
recorder’s power switch. If this sequence is reversed, the
camera-recorder may malfunction due to slow rising of
the AC adapter output voltage.
z When connecting a battery to the DC IN socket, select
the battery type listed under EXT DC IN SELECT. Select
EXT DC IN SELECT from the <BATTERY/P2CARD>
screen on the MAIN OPERATION page. In this case,
however, the % display is disabled, even when using a
digital battery.
5-2 Mounting the Viewfinder and
Adjusting its Position
Please refer to the viewfinder instruction manual.
Note: A slide rail is required to mount any viewfinder other than
models AJ-VF15B or AJ-VF20WB.
z If you need to buy a slide rail, please contact the store where
you purchased the camera-recorder and tell them that the
slide rail is a “repair part”.
Slide rail (VFC3995)
Screws (XBS3+8VZ)
Mounting the Slide Rail
1 Undo the upper two screws for AJ-VF15 or AJ-VF20W, and
remove the mounting unit.
Leave the screws attached to the mounting unit.
2 Mount the slide rail, then tighten the two screws.
DC IN Socket
AC Adapter
z AJ-B75 (Optional)
When using an external power supply other than the AC
adapter AJ-B75, check the DC IN socket pin information to
ensure correct polarity. If a +12V power supply is accidentally
connected to the GND terminal, this could cause a fire or
personal injury.
1
2
3
4
Pin No. Signal
1GND
2, 3
—
4 +12V
DC IN Socket
Mounting unit
Screws
Slide rail