Filter
Top Products
64
Chapter 5 Preparation
5-1 Power Supply
A battery pack or AC power can be used as the power supply for
the camera-recorder.
Using a Battery Pack
Battery packs from the following manufacturers can be used:
• Panasonic
• Anton/Bauer
• IDX
• PACO
• Sony
<Notes>
z Other batteries may be used by changing the menu setting,
but system compatibility is not guaranteed.
z Charge the battery pack with the battery charger before using
it. (Please refer to the battery charger’s instruction manual for
information about charging.)
5-1-1 Mounting the battery and setting the
battery type
Using an Anton/Bauer Battery Pack
1 Mount the Anton/Bauer battery pack.
<For your information>
The Anton/Bauer battery holder includes both a power supply
output connector for lighting and a lighting control switch, which
are convenient when attaching a light. Please contact Anton/
Bauer for information about the lighting system.
2 Insert the battery and slide it in the direction of the arrow.
<For your information>
Removing the battery pack
Completely push down and hold the release lever on the
battery holder. Then, slide the battery pack in the opposite
direction to the arrow while holding the lever down.
3 Setting the battery type.
Select the battery type listed under BATTERY SELECT.
Select BATTERY SELECT from the <BATTERY/P2CARD>
screen in the MAIN OPERATION page.
Please refer to [8-6-2 BATTERY SETTING1] for more
information.
The following Anton/Bauer batteries can be used:
•
PRO14
• TRIM14
• HYTRON50
• HYTRON100
• HYTRON120
• DIONIC90
• DIONIC160
<Note>
To use DIONIC, please set it as DIONIC90.
%$77(5<3&$5'!
%$77(5<6(/(&7352
(;7'&,16(/(&7$&$'37
%$771($5(1'$/$502))
%$771($5(1'&$1&(/21
%$77(1'$/$5021
%$775(0$,1)8//
&$5'1($5(1'$/$5021
&$5'1($5(1'7,0(NJO
&$5'(1'$/$5021
&$5'5(0$,1
NJO
Anton/Bauer
Battery Pack
Lighting control
switch
Power supply output
connector for lighting
Release lever