Filter
Top Products
48
Gain value
__dB Current gain value.
System information
and warnings
SYSTEM ERROR-__
TURN POWER OFF
REC WARNING
BACKUP BATT EMPTY
WIRELESS-RF
EOM
BOS
EOS
CANNOT REC
CANNOT PLAY
VOICE CANNOT REC
VOICE REC
VOICE OFF
VOICE PLAY
MARK ON/OFF
UPDATING
USB DRIVE
THUMBNAIL OPEN
Something abnormal is happening to the internal computer communications or
reference signal. No further recording or playback can be performed. __is
replaced with an error code.For more information, see [7-3-2 Error Codes].
P2 card has been removed while being accessed (recorded, played back, or
formatted), and subsequent operation is disabled.
Something abnormal is happening to video and/or audio being recorded. This
indication stays on until the next recording starts.
Backup battery needs replacing.
RF signal from the wireless receiver is degraded.
P2 card has no free space.
Playback position is at the start of all the clips.
Playback position is at the end of all the clips.
The P2 card is not recordable. Detailed information is provided on the FUNCTION
screen of MODE CHECK . See the relevant section of the MODE CHECK area.
Clip cannot be played back perhaps because no P2 card is loaded, or the P2 card
contains no clips.
Voice memos cannot be recorded, possibly perhaps because the P2 card has no
free space, or 100 voice memos are already recorded on one clip.
Voice memo being recorded.
Recording of voice memo stopped.
Voice memo being played back.
Shot mark been added or deleted. For information on shot marks, see [3-9 Shot
Mark Function].
Clip information is being updated. Playback operation disabled.
AJ-SPX900E is in USB mode. When communication is disabled, the indication
blinks. (To be supported in the near future.)
Thumbnail is being manipulated.
Voice memo
indication
Voice memo being recorded. When the free space for voice memos is less than
one minute, the indication blinks.
Audio input channel
and level meter
- - - - - - - - +
F
W
R
Selected channel together with its audio level.
AUDIO IN switch is positioned at FRONT.
AUDIO IN switch is positioned at WIRELESS.
AUDIO IN switch is positioned at REAR.
Time code indication
TCG 12:59:59:20
TCR 12:59:59:20
(V)UBG AB CD EF 00
(V)UBR 12 34 56 78
TCG (time code generator value)
TCR (time code reader value)
UBG VUBG
UBR VUBR.
DV format indication
DV DV format specified and playback being performed in the DV format.
Iris override
indication
+ +
+
(No indication)
–
– –
Correction phase of the iris override (when active)
+ + : On the open side by 1 +: On the open side by 0.5
– – : On the closed side by 1 –: On the closed side by 0.5
No indication : Standard status
Iris, F value
NC
0PEN
F1.7 - F16
CLOSE
Lens cable is not connected.
Lens iris is at maximum.
Lens iris value
Lens iris closed.
<Note>
These indications are provided when the lens is capable of indicating the iris value.
When the iris is being overridden, they blink.
Zoom indication
Z00 - Z99 Zoom degree is indicated. This indication is not provided for a lens that does not
return the zoom position, even if the indication is set to ON.
PRE RECORDING
indication
P-REC (blink) Indicated while pre-recorded video and audio are being recorded on the P2 card.
ID record indication
ID The ID is set to be superimposed on the video from the camera.
Battery type
PRO14 - AC_ADPT Battery type, selected through a menu option. When the AC adapter is connected,
it is indicated as AC_ADPT.
Battery remaining
level/voltage
__._V
___%
EMP
MAX
Battery remaining level in tenths of a volt
Digital battery remaining level, as a percentage
Digital battery empty.
Digital battery fully charged.
Camera-recorder
REC indication
REC Recording status of the camera-recorder represented as characters when 1394 is
connected. The indication stays illuminated during recording, or blinks when a
warning is given.
Information Item Indication Status
V