Filter
Top Products
32
I/F mode
You may need to change the I/F mode so that
your printer and computer can communicate
properly.
Auto: printer automatically selects the
interface that is receiving data, and uses that
interface until the end of the print job. Allows
you to share the printer among multiple
computers without changing the interface
mode.
Check your computer documentation if you
are not sure of the type of interface your
computer requires.
Auto, Parallel, Serial, USB, Optional
Auto I/F wait time
When Auto is selected as the I/F mode
option, you can set the interface timeout to
10 seconds or 30 seconds. The printer does
not accept data from another interface unless
it receives no data from the current interface
for the period set in Auto I/F wait time.
10 seconds, 30 seconds
Network I/F mode
If your printer is connected to a single
computer, leave this feature off. If you want
to share the printer with another computer,
turn this feature on. When this feature is on,
data may be present in the printer’s buffer
even though the printer is not printing. Always
make sure the printer isn’t receiving data
before turning off the printer.
Off, On
Parallel I/F transfer rate
Specifies the interface transfer rate. For most
printing, leave this setting set to Fast. If you
encounter problems, set it to Normal.
Fast, Normal
Settings Options
basics.book Page 32 Friday, January 8, 1999 11:57 AM