Filter
Top Products
49
Your printout is blurry or smeared.
● Use the PictureMate Photo Paper to ensure proper
saturation, absorption of ink, and quality.
● Make sure you load paper with the glossy side
face up.
● Make sure your paper isn’t damp or curled, or
loaded face down (the glossy side should be face
up). If it’s damp or curled, load a new stack of
paper.
● The print head may need aligning; see page 45.
Your printout is faint or has gaps in the image.
● The print head nozzles may need cleaning; see
page 44 for instructions.
● The photo cartridge may be old or low on ink. To
replace the photo cartridge, see page 33.
● Make sure your paper isn’t damaged, old, dirty, or
loaded face down. If it is, reload a new stack of
paper with the glossy side up.
Colors in your photo are wrong or missing.
● Make sure the Color Effects setting is set to Color
for color photos. See page 19.
● The print head nozzles may need cleaning; see
page 44.
● The photo cartridge may be old or low on ink. To
replace the cartridge, see page 33.
● Try turning on or off Enhance or Fix under the
Auto Correct setting. See page 22.
Problems With Paper Feeding
Paper doesn’t eject fully or is wrinkled.
If it’s wrinkled when it ejects, the paper may be damp
or too thin.
Paper doesn’t feed correctly or jams in the printer.
● Make sure the paper support is pulled up, all the
way out, and is not leaning on the handle. The
handle should be all the way down in back of
PictureMate. Make sure the handle is not resting
on the paper. See page 5.
● If paper doesn’t feed, remove it from the paper
support, reload it against the right edge, then slide
the left edge guide against the paper (but not too
tightly).
● If multiple pages feed at once, remove the paper
from the paper support, separate the sheets, and
carefully reload it.
PictureMate.book Page 49 Wednesday, August 18, 2004 2:48 PM