Filter
Top Products
Technical Specifications
MR-HD100 Media Recorder
187
Error Messages
The MR-HD100 will display error messages on its LCD display if
certain conditions occur that can effect MR-HD100 operation. Below
is a list of the error messages and the actions to take:
Data CRC Errors
CRC (Cyclic Redundancy Check) errors indicate that either a file is
corrupted (this might be a hardware error) or a file system is
corrupted.
CRC’s are caused by any of the following:
• Computer hard drive
• Computer hard drive copying the files
• Computer port
• Computer file system corruption
• Cable, FireWire or USB MR-HD100 hard drive
• MR-HD100 port
• MR-HD100 file system corruption
Error Message Description Action
LOW BATTERY!
Battery power is low. Connect AC Power or replace the battery
pack.
HIGH
TEMPERATURE!
The unit is getting too hot for
normal operation.
Check ambient air temperature. Is unit in
direct sun light or near heat source?
NO SPACE LEFT!
The Disk Drive is Full. Transfer files off the drive and format it
before attempting to do more recording.
DISK ERROR
XXX
Lost Disk Communication. Contact Focus Enhancements Technical
Support.
NO DISK
DETECTED
Lost Disk Communication. Contact Focus Enhancements Technical
Support.
WRONG
PRODUCT ID
Incorrect Software Loaded. Download correct software and perform
upgrade again.
FILE NOT FOUND
Wrong filename or missing file. Check filename or that upgrade file
exists.
AUDIO MUTE
Record or Playback with VF
mode set to 24, 25 or 30 is
muted for the PN NFR formats
(QuickTime PN and P2 PN).
This is normal. No action is required.