Filter
Top Products
Quick Start
MR-HD100 Media Recorder
22
Connecting MR-HD100 to DV/HDV Camera
Before performing this procedure, make sure you have installed and
charged the battery, see
Installing / Removing the Battery Pack on page
20.
1. Connect the supplied FireWire, 1394, cable to the DV I/O
connector on the top of the MR-HD100.
1. Locate the FireWire/DV/iLink (or similar) connector on your
video camera. It is located in different places depending upon the
brand of camera. If you are unclear of its location, consult your
video camera manual.
2. Connect the other end of the FireWire, IEEE 1394, cable to the
video camera.
3. Turn on the camera.
4. Turn on the MR-HD100.
MR-HD100 Supplied with Two FireWire Cables
The MR-HD100 is provided with both 4-pin to 6-pin and 6-pin to
6-pin FireWire cables.
Check to see which type the camcorder requires.