Filter
Top Products
26
1-4 Pull out the cables aside and mount
Preparation (Step 1 Connection/Installation)
1.
Follow steps 3 to 6 of mounting the
Camera to the Ceiling (Preparations)
(
☞
page 16)
2.
Pass the input power cable and video
signal output cable provided with the
camera unit under the plate for
depressing cables.
3.
Follow steps 1 to 6 of mounting the
Camera to the Ceiling (Installation)
(
☞
page 20)
4.
Bundle all the cables into the wire clamp
Bundle the cables coming out from the ceiling
(Video signal cable, Input Power cable, LAN cable
and alarm signal cable etc.) into the wire clamp.
5.
Follow steps 7 to 8 of mounting the
Camera to the Ceiling (Installation)
(
☞
page 21)
6.
Follow “Mounting the Camera to the
Ceiling (adjustment of the camera’s
angle of view)”. (
☞
page 23)
1-5 White-spot correction
As a general characteristic unique to CCDs,
white-spots may appear on the screen with age.
In order to reduce this phenomenon, this unit
is equipped with a white-spot correction fea-
ture.
Switch on the camera power supply and wait
for at least 30 minutes.
1. Remove the dome cover.
2. Cover the lens surface using a black sheet
of paper, etc. so that light does not enter
the lens.
3. Press and hold the SPOT CORRECTION
button on the unit for more than 2 seconds.
* White-spot correction will start. Correction
may take several seconds for completion.
Notes
• Maximum correction: less than 16 to 32 spots
•
The white-spot correction feature of this unit does not guarantee the correction of all white spots.
Depending on the characteristic of white spots, correction may not be possible.
• When performing white-spot correction, accurate data may not be achieved in case of highly
detailed pixels since correction is made using the information of surrounding pixels.
• The result of white-spot correction is maintained until the next correction is performed.
Video signal
cable
Power supply
cable
Plate for depressing
cables
Wire clamp
2.
4.
27
2-1 Installing the Software
Installing the V.Networks Controller
1. Execute "Setup.exe" in the [JVC] folder.
2. Follow instructions on the screen to install the software.
3. If installation is successful, the † "V.Networks Controller" icon will be displayed in the [Start] †
[Programs]
[V. NETWORKS] folder.
Installing the VN-C205U Setup Tool
1. Execute "Setup.exe". This is located inside the [Setup] folder of the [JVC] folder.
2. Follow instructions on the screen to install the software.
3. If installation is successful, the † "VN-C205U Setup Tool" icon will be displayed in the [Start] †
[Programs]
[V. NETWORKS] folder.
Settings (Step 2 Network Settings)
To operate this camera, you will have to install the necessary software according to
the following procedure from the CD-ROM supplied.
~~~~~~~~~~~~~~~~~~~